Best Barns tahoe_1216f Bedienerhandbuch PDF herunterladen (Seite 20)

Straight Edge

Metal Truss Hanger

Soffit Board Flush With Siding

To prevent the nails from protruding

thought the bottom of the soffit board,

do not nail at an angle when nailing roof

sheathing to the soffit boards.

1. Place trusses over the 'X' marks and secure

trusses to 2x4 tie plate using 2x4 hangers and

1-1/2" hanger nails.

2. Locate 84" long soffit boards that have a beveled

edge. Install one of these boards flush with the

top of the siding and butting against the rear

gable trim. Secure soffit boards to the top wall

plate with 3" long screws. Cut to length and

install the last soffit board to fit behind 2x3

boards on the front gable.

Step 20 Install Trusses & Soffit Boards

1. Install a 42" x 96" OSB roof panel flush with

the face of the rear gable trim. Use a straight

edge to align the top of the sheathing with the

top of the truss. Continue adding sheathing

following the layout on the next page. Use

7d sinkers, spaced 12" apart.

2. Repeat step for opposite side.

Step 20 Install Roof Sheathing

Before installing the overhang to the

sidewall, use a straight edge to make

sure the trusses are align with the bevel

cut on the overhang board. Adjust up

or down if necessary.

Straight edge

1 2 ... 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Best Barns tahoe_1216f Bedienerhandbuch Seite 20